But it refuses to send data back. Has anyone played with the command line triggers for the TNCserver? I may have overlooked something. Any help would be greatly appreciated. That might tell you if the line is being held high or low. Create an account or sign in to comment You need to be a member in order to leave a comment Create an account Sign up for a new account in our community.
|Système d’exploitation:||Windows, Mac, Android, iOS|
|Licence:||Usage Personnel Seulement|
About a year ago a computer was connected to that specific TNC everything was fine and it did not really need any settings or anything. Sign up for a new account in our community. But it refuses to send data back. I have tried various changes in the machine parameter codes with no luck. The TNC B controller was installed in or Tags for this Thread everyone , saw , welcome.
It looks as though the Server side of this software is what you need to use what little i have looked at it.
CoeJanuary 23, in Industrial Forum. Machine Tncrrmont Software and Solutions. Or sign in with one of these services. Tags for this Thread everyonesawwelcome.
PC software and manuals
I send random values random keyboard presses in the terminal and I got an « Erroneous data The problem is simple. I tried 3 computers but same problem. Control Procedure for input of command line parameters: I will look at trying to set up the controller for an ethernet connection although I don’t tnceemont it is capable.
Posted January 23, Posted January 24, Follow us on All times are GMT I tryied to initiate comunication by hand but I could gncremont get any info about the communication protocol. Sign up for a new account in our community.
HEIDENHAIN -> iTNC PC-SOFTWARE > operate iTNC with TncRemoNT
Register a new account. Do you have TNCServer installed? Has anyone played with the command line triggers for the TNCserver? I sometimes get an « Unable to establish connection error » or the program just locks up. Subscribe to eMastercam News. I even tryied to send data to the computer in FE mode seeing the data on a terminal yet again the Heidnhain sends absolutely nothing to the pc.
About a year ago a computer was connected to that heivenhain TNC everything was fine and it did not really need any settings or anything. I was able to get a transfer rate on the slower two just as fast as the TNCi by using the built in converter to convert ASCII code to binary format as it sends the code.
This message will be removed once you have signed in.
Results 1 to 9 of 9. I have wired a direct connect cable between the CNC and computer as shown in Heidenhains service manual.
TNCremo – Klartext-Portal
Sign in with Twitter. Create an account or sign in to comment You need to be a member in order to leave a heidejhain Create an account Sign up for a new account in our community. If you are using an older model Heidenhain controller you will make a massive saving in transfer time if you set up the ethernet.
I also check the cable tha connects the outer SUBD25 connector up to the internal electronics and all is fine. I have done some programs with the TNCcmd.
Already have an account? But it refuses to send data back. Use your display name or email address heidenhaij sign in: Industrial Forum Existing user?
It works like a dream and was easy to setup. The thing is that everything is exactly as it should just no data goes out of the TNC.